This has its own set of help files to assist you in getting the Crestron side up and running.
#Crestron simpl clear all logic driver
There is a demo program included in the Driver Pack.This allows you to easily bring the two together
We had a few requests where Crestron lighting was in place, but the dealer wanted to change the front end to Control4.What communication connections can I use?.Example: Shade ID 30 in Control4 gets address’s:.Example: Relay ID 21 Load 7 in control4 will get and address of 2107.Example: Dimmer ID 10 Load 4 in Control4 will get an address of 1004.Address, which will be a four-digit number followed with the load no as a 2-digit value:.Shade motors (DIN-2MC2): "HM_Relay_Interface.c4z".
#Crestron simpl clear all logic drivers
Matching Control4 drivers can be found for dimmers, relays and motor control. It is suggested to simply change logic to match new device ID no.Press F9 to simply change programming to match new Cresnet ID. Copy and paste the correct associated folder. For each Dimmer, relay or motor controller add new required Cresnet device.Otherwise just bind the RS232 connection from a Control4 controller to a Crestron Processor. The Control4 driver "HM_Crestron_Lighting.c4z" in Composer will get the IP address of the Crestron Processor in Connections – IP Connections if using IP.The program uses a TCP/IP Client (already added) to talk to the Control4 system.Last Address Received – Will allow you to see the address received from Crestron so that you can copy it to the address property of the lighting drivers mentioned above.Debug Mode – Set to print to troubleshoot the driver.